Kitchen cupboard pull-out basket how to put the bowl

Nowadays, most people install pull-out baskets inside the kitchen so that the bowls are placed more neatly. Here is a small introduction to how to put bowls in the kitchen cupboard pull-out basket.

Kitchen cupboard pull-out basket how to put bowls

Generally speaking will cupboard pullout upper layer to put dishes, in the lower layer is to put some pots and pans and other large kitchen utensils, so that the matching put more neatly, dish basket placement needs to maintain the "vertical" principle, this can solve the problem of draining, while taking will also be more convenient, the same volume of drawers, vertical placement than stacked capacity is relatively large.

How to buy the correct cabinet pullout?

1. Wire

Need to look at the thickness of the wire and quality, especially the quality of thickness is also relatively distinguished out, but the quality is not so simple, this is also to make the cost of reducing some, there are many small businesses will also have two of the same wire, its built-in diameter is relatively small, such as 6 mm, only 2 to 3 mm in diameter. In terms of structure is also relatively simple, live by weight to distinguish, lighter is of inferior quality products

1

2. Effect of plating

Plating can be said to be a more important part of the construction, in knowing that the kitchen is a more humid place, so the installation of kitchenware should be with a strong corrosive, it can be said that the effect like plating determines the ability to prevent corrosion and rust.

3. Guideway quality

A substandard guide in use is also prone to rust, once rusted will lead to push and pull is not so smooth, put too much stuff is also easy to make this deformation, it is recommended to choose to use stainless steel chrome plated guide.

4. Appearance

From the appearance, not to be more good-looking, but to be neat and uncluttered, the four corners need to be at 90 degrees, the four sides of the frame need to be balanced, the base material must be uniform, the surface layer is not coated, so that people feel there is no burr and pockmark on the surface.


Post time: Mar-02-2023
Write your message here and send it to us